- ²úÆ·ÏêÇé
Ìص㣺
±ÈÀý¸ßѹµçÔ´£º¸ôÀëÊä³öµçѹÓëÊäÈëµçѹ³ÉÕý±È
³¬Ð¡³ß´çºÍÇáÁ¿¼¶
¸ßЧÂÊ
¸ôÀë¸ß´ï 500 Vdc
Âß¼ ON/OFF ÊäÈë
²ÎÊý£º
Parameters | Specifications (at Tamb=25¡æunless otherwise specified) | ||||||||
Input voltage Vin(pins 1&3) | ¡¤2.5 to15Vdc(absolute maximum:30Vdc,see protection section for details) ¡¤Reverse:-0.2Vdc max. ¡¤Turn on voltage:2.5Vdc typical | ||||||||
Efficiency | >75%at full load (input current in off state <4mA) | ||||||||
HV output Vout (pins 5,6&7) | Output voltage is proportional to the input voltage | ||||||||
Output polarity | Customizable (see diagram below for details) | ||||||||
Nominal output current & Residual ripple | Version | Output voltage | Output cur- rent | Ripple (Fs~50kHz) | |||||
1K Series | 1 kV (2x0.5kV or 2x1kV) | 6 mA | <1% | ||||||
2k Series | 2 kV (1x2kV or 2x1kV) | 3.0 mA | <1% | ||||||
4K Series | 4 kV (1x4kV or 2x2kV) | 1.5 mA | <1% | ||||||
Switch frequency | 50 to 70kHz | ||||||||
Load voltage regulation | +40%for full load to no load.(see diagram below) | ||||||||
Temperature coefficient | <300ppm/¡æ | ||||||||
Operating temperature range | -10¡æ to+70¡æ(case) | ||||||||
Storage temperature range | 40¡ã¡æ to+125¡æ | ||||||||
HV power ON/OFF (pin 4) | Connect Pin 4 to Vin return(pin3)to activate the HV output. Compatible with open collector switches,relay.. | ||||||||
Safeguards &Alarm(pin 2) | ¡¤Over voltage at the input is detected above 15Vand themodule automatically turns off ¡¤Thermal detection automatically turns off the module above 70¡æ ¡¤Alarm is a logical 5V output which turns high when Vin>15v or when the thermal protection occurs. The converter resumesnormal operation once the fault condition dis- appears. | ||||||||
Shielding | The metal case is internally grounded to the Vin Return pin 1 | ||||||||
Pins | 0.63x0.63 mm square pins Length:>2 mm | ||||||||
Weight | <40g | ||||||||
Insulation | Fully potted in an ULcertified epoxy resin |
¶©¹ºÖ¸ÄÏ£º
PRV15-D4-6
PRV15-D1-6
PRV15-D2-6
PRV15-S1-6
PRV15-S2-6
PRV15-S4-6